Capstractcond-matcapstract:2611.00042

Physics > Materials Science

Title:Flexural rigidity of packing inserts bearing canceled handling instructions

Abstract:

Raised lettering on a packing insert uses material which can also serve as a face reinforcement. We calculate the flexural rigidity supplied by a three-line DO NOT BEND stamp under imposed cylindrical curvature. Four dies issue the instruction, append an exclamation mark, underline it, or cancel it with two diagonal strokes. All deposit the same volume on a symmetric sheet. Cancellation reduces the reinforcement measured along both print axes, yet raises its minimum over bend directions by 13.7%. The exclamation mark lowers the minimum by 1.8%. For a 0.25 mm substrate with 0.10 mm ribs, the calculated difference between issued and canceled stock is 0.056 N·mm in total cylindrical rigidity at their respective weakest orientations. Allocating 24.6% of the resin to cancellation maximizes the minimum for this block. A single-width die assigns 26.5% and comes within 0.15% of the optimum. Reducing the width of the stamp to 75% of nominal reverses the ranking.

Comments:3 pages, 3 figures, 1 table.
Subjects:Materials Science (cond-mat.mtrl-sci); Soft Condensed Matter (cond-mat.soft)
Cite as:capstract:2611.00042 [cond-mat.mtrl-sci]
 (or capstract:2611.00042v1 [cond-mat.mtrl-sci] for this version)

Submission history

From: M. Vale
[v1] Fri, 20 Nov 2026 21:08:47 UTC (125 KB)

Current browse context:

cond-mat.mtrl-sci
< prev  |  next >
Change to browse by:

Export citation